Why That The ATT Router WPS Button Red?

WPS (Wi-Fi Protected Setup) is a secure wireless connection method by which you can connect a WPS-supporting device to your router without having to enter the wireless network credentials. If your ATT router WPS button red, it means the WPS connection has been disabled.

ATT router WPS button red

The red light will stay for 5 minutes or until the WPS button is pressed again. The flashing red light on your AT&T router indicates that a session overlap has occurred. It continues for 2 minutes and leads to security risk. To fix the WPS red light issue on your AT&T router, follow the steps mentioned below.

Solution 1: Set up your wireless device properly to the wireless network using the WPS configuration

  • If the red light is still on, press the WPS button again.
  • If necessary, unplug the power cord and restart your router after a few seconds.
  • Make sure that it is correctly connected to the modem.
  • Wait until the router’s power LED turns solid green, or is in the standby mode.
  • On your wireless device, turn on the Wi-Fi and prepare for the WPS configuration.
  • Within two minutes, navigate to the AT&T router and press the WPS button.
  • Once the gateway is ready for WPS authentication, will stop glowing in red.
  • You can ensure that the connection is established when the WPS LED turns solid green.
  • If the problem ATT router WPS button red is persists, move on to the next solution.

Solution 2: Reset the AT&T router to factory default Settings

  • First, locate the Reset button on your AT&T router. Most probably, it will be available on the lower rear of the router.
  • Use a paper clip or steel pin to press the Reset button.
  • Hold it for at least 15 seconds.
  • The LEDs on your AT&T router will start flashing.
  • Once the router is reset, reconfigure the WPS settings and check if the problem ATT router WPS button red has been resolved.
Top