How To Solve Belkin Router Not Working After Reset?

 Belkin Router Not Working After Reset

Is your Belkin router not working after reset? Then there might be an incorrect reset.

To perform an exact reset, follow the quick steps given below.

  • First, try restarting your router and modem.
  • Disconnect the router and modem.
  • Unplug the power cord connecting the router to the power outlet.
  • Wait for a few minutes and then power up the router.
  • Restart the modem as well.
  • Connect the router to the modem.
  • If the problem persists, you need to update the settings on your router.
  • To access the router’s settings page, you have to determine the router’s IP address. To do so, enter ‘ipconfig’ in the Command Prompt window and press Enter.
  • Navigate to the Default Gateway section and note down your router’s IP address.
  • Use it to open the router’s login portal on your default browser.
  • Enter ‘admin’ as your username and password on the router’s login portal and click the Login button. This will direct you to the router’s settings page.
  • On your router’s settings page, update the network settings and save them.
  • Once all the settings are updated, check if the problem has been resolved.
  • If the problem persists, update your router’s firmware.
  • If the issue persists, proceed to reset the router.
  • Press the Reset button, which is usually located at the rear of the router.
  • Use a paper clip or a pin-like metal to press the Reset button. Hold it for at least 15 seconds.
  • The LEDs on your Belkin router will flash when the resetting process is being carried out.
  • Wait for a few minutes for the router to restart automatically.
  • Now, your belkin router not working after reset to the factory defaults. Check if it works.

Related Articles

Top