A reset should be done if your router does not work properly. The following issues might cause with your router. If the router's wireless signal is not strong enough, then the device might not function properly. If you have forgotten your password to connect, then you should reset your router with the following guide how to reset Netgear router. Also, if the Wi-Fi card is not detected, reset your router. This issue may occur if network drivers aren't installed properly. The place where you have positioned your router might not receive a proper signal. This will also lead to the router not working issue. Hardware issues might also refrain the router from working properly. If any Operating system corruption has occurred, the router will fail to work.
FIND THE "RESET" BUTTON
Netgear routers possess a Reset button that can be used to reset when an error occurs. The Reset button will be present at the back side of the router. Go near the router and make sure you are looking at the back side of it. The Reset button will be present with a label under it.
INSERT A PAPER CLIP INTO THE RECESS.
For how to reset Netgear router, the reset button is very small and cannot be handled easily with your hands. You should make use of a paper clip or pin to press the Reset button. Search for a paper clip. Once you find it, bend it slightly. Insert it into the Reset button.
TAP THE RESET BUTTON AND HOLD IT FOR 7 SECONDS
Insert the paper clip into the Reset button and hold it for at least 7 seconds. Hold it firmly without dropping. If you drop it halfway through the process, then it will be canceled. So, ensure that you press it for the entire time specified here.
RELEASING THE "RESET" BUTTON
After holding the Reset button for 7 seconds to 10 seconds, release it. Eject the paper clip slowly in the backward direction to release the button. Removing it fast might cause damage to the Reset button. The Reset process will begin after you release the button.