Troubleshooting Linksys Wireless G Broadband Router

Troubleshooting Linksys Wireless G Broadband Router

A few of the common methods to troubleshooting Linksys wireless G broadband Router are mentioned on our web page.

Cannot connect to the internet:

  • Check if the Linksys wireless G broadband router is turned on.
  • The power LED on the router must be green and it should not blink.
  • If the power LED is blinking, turn off your computer, modem, and the router.
  • First, power up the modem.
  • After a while, turn on both the Linksys router and the computer.
  • Check if you can access the internet from the computer.

Computer not connecting to a wireless network:

  • Make sure to use the correct SSID (network name) and password (network key).
  • If you have enabled the wireless security on your router, check if you are using the same security method and key for both the computer and the Linksys wireless G broadband router.

Avoid the login credentials prompt:

  • Open the Internet Explorer web browser, navigate to the Tools menu, and select Internet Options.
  • Navigate to the Connections tab, select the Never dial a connection option, and click the OK button.

Slow downloads:

  • On the computer, right-click your connection type and choose the Properties option.
  • This will launch the Local Area Connection Properties dialog window to troubleshooting Linksys wireless G broadband Router.
  • Navigate to the ‘This connection uses the following items’ section, deselect the checkbox beside the Internet Protocol Version 6 (TCP/IPv6) option, and OK option.

Cannot access the web-based setup page:

  • Check if you have entered 192.168.1.1 in the web browser’s address field.
  • On the login page, leave the Username field and type admin in the Password field.
  • If you have changed the password, use it instead of the default one.
  • If you have forgotten the changed password, reset the Linksys wireless G broadband router by performing the instructions mentioned below.

Resetting the router:

  • Locate the Reset button at the rear panel of the Linksys router and then hold it for five seconds.
  • Use a paper clip or similar objects to press and hold the Reset button.
  • This will reset the Linksys router to the default settings.
  • Now, use the default login credentials to access the Linksys wireless G broadband router’s web-based setup page.
  • Customize the wireless settings correctly.
  • If you have any doubt in troubleshooting Linksys wireless G broadband Router problem, get assistance from our technical support member by clicking the Call button mentioned on this web page.

Related Articles

Top