Linksys WRT3200ACM Internet Light Blinking - [SOLVED]

Some technical problems may result in the Linksys WRT3200ACM internet light blinking error. Those problems are listed below.

Issue with the cable connection
ISP issues
Issue with router firmware
Settings issue

These problems might cause the internet light to blink in the linksys WRT3200ACM router. Try the below solutions on how to resolve the Linksys WRT3200ACM internet light blinking error.

Check the Internet status:

Remove the power cable from the router and the modem.

Unplug the Ethernet cable from the modem and Linksys router.

Attempt to connect the modem directly to the router using the Ethernet cable.

Connect the power wire to the modem only. After 2 minutes, check if the internet connection is properly working.

If you are able to access the internet, then it means that the issue is not with the internet connection. The problem might be with the router or the cable connection.

Verify the connection between router and modem:

The modem may not be connected to the correct slot in the router. To fix this issue,

Disconnect the power adapter from the DSL modem and router.
Try to connect the DSL modem from the router’s WAN port.
Next, connect the power adapter to the router and modem.
Power on the modem and wait for 35 seconds. Then switch on the router.

After doing the above steps, verify if the Linksys WRT3200ACM internet light blinking problem is resolved.

Recheck the Internet settings:

The ISP offers a different type of internet connection for its users. While configuring the router, enter the correct internet settings. If the internet settings are incorrect, the router will not be allowed to access the internet.

Try to clone the Mac address:

Connect your computer and the router’s LAN port using an Ethernet cable.
The PC should be disconnected from the Wi-Fi.
Open a browser and then type your router’s IP address in the address bar.
When prompted, input the username and password of your Linksys router.
Go to the mac address clone option.
Select the Clone my PC’s mac address button.
Choose the Save settings button.
The router will reboot. Check if the issue is resolved.

If the issue persists, update the router firmware. Then see if the Linksys WRT3200ACM internet light blinking problem is resolved.

If none of the solutions could troubleshoot the issue, factory reset the router.

Press and hold the Reset button on the router for around 45 seconds.
Release the button. Then restart the Linksys Wi-Fi router.

Now, check if the Linksys WRT3200ACM internet light blinking problem is resolved.