Complete Guide For Netgear Adsl Router Configuration

Are you looking for a solution to connect your Netgear router with the ADSL modem? Then you need to go through this article. Carry out the steps mentioned below to configure your Netgear ADSL modem with the help of a computer. Before starting the Netgear ADSL router configuration, you need to have the information regarding the Internet connection type, ISP’s login credentials, multiplexing method, and VPI & VCI values.

The first step is to execute the physical setup.

Connect the Netgear router to the ADSL modem using the supplied cable.

Connect the LAN port of the Netgear router to the computer using a standard Ethernet cable.

Now, turn on all the devices and wait until the Netgear router is ready for preparation.

On your computer, open the Command Prompt app and type the “ipconfig” command to identify the IP address of the Netgear router.

It will be available near the Default Gateway field.

Next, open the default browser and type the Netgear router’s IP address in the URL field.

Enter “admin” as your username.

Enter “password” in the password field to log in to your router’s interface.

If you are setting up the Netgear router for the first time, you can access the Netgear genie Wizard for easy setup.

Otherwise, you can go with the Netgear Smart Wizard to configure the necessary settings.

If you are using the Netgear genie Wizard, click the “No, I want to configure the internet connection myself” radio button and click the Next button for a manual configuration.

Click the Basic tab and select Internet from the left-side panel.

Under the “Does your Internet connection require a login?” section, click the Yes radio button.

Click the Internet Service Provider drop-down menu and select PPPoE as your ADSL service.

Enter the ISP’s username and password in the required fields.

Next, click the Apply button to save the applied settings.

Choose the Dial on Demand, Always-On, or Manually Connect option as your connection mode based on your wish.

Click the Advanced tab and select the Setup button from the left-side panel.

Select ADSL Settings from the drop-down menu and go to the right-side panel.

Select either VC-Based or LLC-Based from the Multiplexing Method drop-down menu.

Enter the VPI and VCI values provided by your ISP.

Finally, click Apply to save the applied settings.

To verify the IP address, click the Advanced tab and check the IP address under the Internet Port section.

If you aren’t able to get the Internet IP address, click the Connection Status button, followed by the Connect button to obtain a valid IP address.

Are you finding it to be difficult for Netgear Adsl router configuration, then contact our technical support team for remote assistance.

Steps For Netgear Adsl Router Configuration