Netgear Nighthawk X8 Ac5000 Router Setup - Quick Steps

 netgear nighthawk x8 ac5000 router setup

This article deals with the Netgear Nighthawk x8 ac5000 router setup procedure. Follow the instructions given below and set up your router. The Netgear Nighthawk x8 ac5000 router’s package comprises the power adapter and a yellow Ethernet cable along with the device.

Where to place your router?

Access your network using the router from anywhere within the operating range of your Wi-Fi network. Based on the physical placement of your router, the operating range of your Wi-Fi connection will vary.

  • Place your router near the computer and other devices that need network connection (Wi-Fi).
  • Ensure that the router is kept within the range of the AC power outlet.
  • Locate the router in an elevated location. Reduce the ceilings and number of walls between the router and other devices.

Connecting the router to the modem:

  • Disconnect the modem’s power supply. If the modem makes use of a battery backup, then remove the battery.
  • Power on your modem.
  • Take the yellow Ethernet cable and connect it between the modem and the router’s internet port for Netgear Nighthawk X8 ac5000 router setup.
  • Next, take the power adapter and connect it to the router. Then plug the power adapter’s other end into a power outlet.
  • Locate the Power ON/OFF button on the router’s rear panel and press it.
  • Press the LED button to change the LED mode. When the LED button is pressed, it will stop blinking. Press the LED button again. Now, this will turn off all the LEDs except the power LED.

Configure the router:

  • To configure the router, you must connect your computer to the router network.
  • You can connect the computer to the router using an Ethernet cable or connect directly to the wireless network of the router.
  • For the Ethernet connection, connect the Ethernet cable between the Ethernet port on the computer and the LAN port on your router.
  • For the wireless connection, turn on Wi-Fi on your computer and select your router’s SSID. Then, enter the wireless password of the router to get connected.
  • Now, open a browser on your computer and enter https://www.routerlogin.net in the address bar.
  • This will automatically initiate the router setup. Follow the instructions, connect the router to the internet, and complete the Netgear Nighthawk x8 ac5000 router setup.

Related Articles

Top