Netgear Router All Lights Flashing

Netgear router all lights flashing problem may occurs due to some of the problems on your router. Follow the insructions to solve this issue.

Netgear Router All Lights Flashing

Some common symptoms that indicate the Netgear router is in trouble are:

  • Amber color Power LED
  • Power LED is solid amber
  • Power LED blinking
  • Power LED does not turn green or white
  • The device cannot go online
  • Device not receiving a valid IP address

Follow the directions given below to resolve the Netgear router all lights flashing on your router:

  • Turn off your router and then turn it on to see if the power LED is blinking and turning to green or white color.
  • You can reset the router. At the rear end of the router, you will see a reset button.
  • Press and hold the reset button for a few seconds.
  • If the Power LED is still blinking, you can then connect the computer to the LAN port of the router to manually configure the settings.
  • Set your IP address, subnet mask, and the default Gateway to static.

To set the settings to static, follow the directions given below:

  • Navigate through the options, Start > Control Panel > Network and Sharing Centre.
  • Click the option Change adapter settings to solve Netgear router all lights flashing.
  • Right-Click on the Local Area Connection or Wi-Fi option.
  • Select Properties and navigate to the option IPv4.
  • Click Properties and select the option Use the Following IP address.
  • Enter the proper information for the IP address, Subnet mask, Default gateway, and DNS Server in the respective fields. Click OK.
  • The computer will display a static IP address.
  • Once you have done setting the information to static, click the Start menu and open Command prompt.
  • You can also open the command prompt from the run command, using the shortcut keys - Windows + R keys.
  • When the run command opens, type cmd and press the enter button.
  • In the command prompt, type ping 192.168.1.1 and then hit Enter.
  • If the system gives out replies, you can close the command prompt and simply reset the router to the factory settings.
  • Log in to the router page with the provided IP address and the default credentials.
  • Once you log in to the router page, you can update the firmware of the router to avoid any further occurrence of the blinking LED in the Netgear router setup.
  • Click the Advanced tab and click Router Upgrade from the left side of the page.
  • On solving Netgear router all lights flashing problem, Click Browse to check for any new update for the Netgear router. If there are any, the router will automatically download it and will be up-to-date.

Related Articles

Top