Setting Up Netgear Router Mac Address Filtering

Netgear Router Mac Address Filtering

MAC address filtering allows you to whitelist and blacklist devices easily. If you want only a few devices to get connected to your network, you can set up Netgear router mac address filtering to allow network permits to those devices alone.

MAC Address filtering On A Netgear Router.

  • First, connect your computer to your Netgear router using an Ethernet cable.
  • Connect the Ethernet cable to a LAN port on the router and plug in the other end to your computer.
  • The IP address of the Netgear router is required to log in to the web-based setup page of the router.
  • Go to the Start menu and type “cmd” in the Search section.
  • Right-click on the Command Prompt app and select Run as administrator.
  • Now, enter ipconfig in the Command Prompt window and hit the Enter key.
  • You can find the IP address of the router in the Default Gateway section.
  • Enter the IP address of the Netgear router in the address bar of your browser.
  • Type your username and password and click Login.
  • The default credentials of the Netgear router are as follows.
  • username - admin
  • password - password
  • Go to the Advanced tab and click Wireless Settings.
  • Click the Setup Access List button in the Wireless Card Access List section.
  • Now, you can start MAC address filtering by clicking the Add button.
  • Type the name of a device you want to add to your network in the Device Name field and enter the MAC address of the device correctly. Then, click on the Add button.
  • Add all the devices you want to connect to the network by following the same procedure.
  • Once you have added all the devices, click the Apply button.
  • Now, your wireless network can be accessed by only the devices you have added. If you have any further queries regarding Netgear router mac address filtering, click the call button.

Related Articles

Top