To perform the packet tracer configuring a Linksys router, carry out the easy steps provided below.
Connect the Linksys router to your computer using an Ethernet cable.
Check if the green LED stays lit.
To ensure whether the connection is established successfully, open the Command Prompt window on the computer and enter ipconfig.
You can check the network information of the Linksys router in the Command Prompt window.
Use the IP address, username, and password to access the web-based setup page of the router from the default web browser.
Internet Connectivity:
Choose the Static IP option from the Internet Connection Type drop-down menu.
Fill the Internet IP Address, Subnet Mask, Default Gateway, and DNS fields with the correct information for packet tracer configuring a Linksys router.
Network Setup:
Navigate to the Network Setup section, provide the correct details in the following fields, and click the Save Settings option.
IP Address
Subnet Mask
Starting IP Address
Maximum number of Users
Now for packet tracer configuring a Linksys router, the internet connection will be lost as the IP Address of the Linksys router has been changed.
Go back to the Command Prompt window on the computer, type the ‘ipconfig /renew’ command without the quotes, and press the Enter key on the keyboard.
Enter the new IP address to access the web-based setup page of the Linksys router.
Go to the Status tab and check if the internet connection settings are correct. If not, change them.
Navigate to the Wireless tab and choose the Disable or Mixed option from the Network Mode drop-down list.
If you do not have a wireless device, choose the Disable option.
If you have the wireless device that consists of B, G, or N, you need to select the Mixed option.
If necessary, change the network name or SSID of the Linksys router.
Select 40MHz in the Radio Band Wide field and click the Save Settings option followed by the Continue option.
Click the Wireless tab and select the Wireless Security option.
Choose the WPA2 Personal option from the Security Mode drop-down list.
Leave the Encryption Mode setting as it is and then set a passphrase.
Save the changes by selecting the Save Settings option.
Click the Continue option, go to the Administration tab, and change the password of the Linksys router.
After saving the changes, you will be prompted to type the administration name and password.
Finally on packet tracer configuring a Linksys router, configure your wireless device to access the internet connection.