How TO Configure Tp-Link Archer C9 Router Setup?
The TP-Link Archer C9 router is a wireless, dual-band, gigabit router. This router can meet the requirements of the Small Office/Home Office networks. This router has an intuitive web interface and so can be set up easily and quickly. You need to keep the router in a place where it can be connected to the power source and multiple devices. Choose a location that is away from Bluetooth devices and cordless phones. Scroll down this page to get TP link Archer c9 setup.
Let us now see how to perform the TP-Link Archer C9 router set up.
- In case you have the Internet connection via an Ethernet cable from the wall socket instead of the cable/DSL/satellite modem, follow these steps. Otherwise, proceed with the steps starting from the installation of the antennas:
- Connect the Ethernet cable directly to the Internet port on the Archer C9 router.
- Confirm that the Power LED, 2.4 GHz LED, 5 GHz LED, and Internet LED are on and solid.
- The first step is to install the antennas.
- The second step will be to turn off your modem. In case it has a backup battery, remove it.
- Make use of the Ethernet cable to connect the modem to the Internet port on the Archer C9 router. Then, continue with the steps to perform your TP link Archer c9 setup.
- You can now turn off the modem. Wait for approximately 2 minutes for the modem to restart.
- It is now time to turn on the router.
- Confirm that the LEDs given below are on and solid. Once you have checked them, you can continue with the setup.
Important Note: In case the 2.4 GHz and the 5 GHz LEDs are off, you have to press the Wi-Fi button on the side panel for 2 seconds. Wait patiently for a few seconds and then check if both the LEDs are on.Now, the hardware part of the setup is over. We shall start with the configuration through the web browser. So, read the next section to know the procedure to perform the TP link Archer c9 setup.